T
O
35C2-3-442-2
P-8-627-34
T M 5-6115-457-34
TM-07464A-35
CHAPTER 9
BASE ASSEMBLY, STOWAGE TOOL BOX, AND FUEL TANK REPAIR
INSTRUCTIONS
BASE ASSEMBLY
Section I.
GENERAL.
9-1.
4. Remove batteries and rollout
The base is a welded structure that
tray,
supports the generator set and the fuel tank.
It consists of tubular cross members, fork-
b. Remove housing as specified in
lift openings, and ground stud The engine
and generator are mounted to the base, the
engine front support and generator mount-
c . Remove generator as specified in
ing provide a three point support system
for the engine and generator. A battery
and rollout tray assembly is mounted in
ci. Remove engine as specified in
the front end of the base and a stowage tool
box in the rear end. Each end of the base
is equipped with a tubular cross member
DISASSEMBLY .
9-3.
which permits connection of a towing
device for skidding the generator set, for
Refer to figure 9-1 and disassemble
short distance moving. Openings are pro-
base assembly in the order of index n u m -
vided in the base to permit the generator
bers assigned. Pay particular attention
set to be lifted by a forklift, The base is
to the following:
equipped with a split-stud terminal to per-
mit electrical grounding of the set.
REMOVAL
9-2.
a. Tag hoses (1, 2, 3, and 4) with
l o c a t i o n prior to removal
Remove the following assemblies
b. Disassemble stowage tool box (19)
from the base assembly:
as specified in paragraph 9-11.
c. Remove fuel tank (53) through stow-
a. Refer to Operator and Organizational
age tool box opening. Disassemble fuel
M aintenance Manual and perform the
tank (53) as specified in paragraph 9-19.
following:
9-4.
C LEANING.
1.
Drain coolant from the radiator.
WARNING
2 . Drain fuel from the day and
Cleaning Solvents are flammable and
fuel tank.
moderately toxic to skin, eyes and
respiratory tract. Eye and skin
3. Drain lubricating oil from engine
protection required. Good general
ventilation is normally adequate.
WARNING
a. Clean parts with an approved clean-
ing solvent and dry thoroughly. If neces- -
When disconnecting bat teries (lead-
sary, remove hand deposits using a bristle
acid) disconnect negative terminal
first.
brush.
Change 8
9-1
