P-8-627-34 T O 35C2-3-442-2
T M - 0 7 4 6 4 A - 3 5 T M 5-6115-457-34
Legend to figure 9-1:
Hose
Plug
42.
22.
Washer (1)
1.
2.
Hose
43.
Elbow
Filler panel
23.
3.
Hose
Screw (2)
44.
Screw (2)
24.
4.
Hose
Washer (2)
45.
Nut (2)
25.
5.
Elbow (5)
46.
Washer (2)
26.
Bracket
Tee (2)
6.
Screw (4)
47.
Ground rod plate
27.
7.
Cross
Nut (4)
48.
Nut (4)
28.
49,
Washer (4)
Nut
8.
29.
Rear tank stop (2)
Nipple
9.
Bevel washer (8)
Screw (6)
30.
50.
10.
Washer
Nut (6)
31.
51.
Tee bolt (4)
Screw (4)
11.
Washer (12)
32.
52.
Strap (2)
12.
Lock washer
(4)
Fuel tank assembly
33.
Bracket (2)
53.
13.
Nut
Screw (2)
Washer (4)
34.
54.
14.
Nut (2)
35.
55.
Ground stud
Upper filler
panel
*56.
15.
Upper filler
panel
Lock washer (3)
Washer
36.
57. Auxiliary fuel hose
Screw (4)
16.
Heater exhaust plate
37.
Nut (8)
17.
Elbow (2)
38.
58. Screw
18.
Washer (4)
39.
Elbow
5 9 . Nut
19.
Stowage tool
box
40.
Cross
60. Auxiliary fuel hose mount
20.
Screw (2)
41.
Nipple
61. Base
* Applicable to serial numbers
21.
Lock washer
(2)
1 through 130
b. Clean sealant from pipe threads
e. I n s p e c t support brackets for
using a wire brush.
distortion.
9-6.
REPAIR.
INSPECTION.
9-5.
WARNING
a. Inspect parts for cracks, breaks,
Welding operations produce heat,
and defective welds.
highly toxic fumes, injurious
radiation, metal slag and air-
borne particles. Welding gog-
CAUTION
gles, with proper tinted lenses,
apron or jacket and welder 's
I f hose blockage is due to deteri-
boots are required.
oration of internal portion of hose,
a . Weld cracks, breaks, and defective
hose shall be replaced.
welds.
b. Repair damaged threads by chasing
b. Check hose for blockage, chafing,
using a suitable die or tap.
and condition of end fittings.
c. Straighten distorted support brackets.
d. Remove damaged paint with a suitable
c . Inspect bevel washer for deteriora-
s c r a p e r . Blend in edges, prime, and paint
tion, cracks, and permanent set in washer
damaged areas.
contact surface.
d. Inspect threads for damage.
9-7.
REASSEMBLY.
Change 8
9-3
