T
O
35C2-3-442-2
P-8-627-34
T M 5-6115-457-34
TM-07464A-35
f. Install and align stowage tool box (19)
Refer to figure 9-1 and reassemble
base assembly in the reverse order of
so that it is flush with base (61).
i n d e x numbers assigned. Pay particular
attention to the following:
INSTALLATION.
9-8.
a. Reassemble fuel tank as specified in
Install the following assemblies on
b. Reassemble stowage tool box as
the base assembly.
specified in paragraph 9-15.
a. Install engine as specified in para-
c. Apply thread sealing compound con-
graph 2-8.
forming to Military Specification MIL-S-
45180, type III, to pipe threads prior to
b. Install generator as specified in
installation.
c. Install housing as specified in para-
graph 3-6.
d. Install fuel tank (53) in base (61)
WARNING
through stowage tool box opening, making
sure that fuel tank needle valve is toward
When connecting lead-acid batteries
opening. Push tank against front stops,
c o n n e c t positive terminal first.
hold tank in position, and install rear tank
d. Refer to Operator and Organizational
stops so that stops hold tank in position.
Maintenance Manual and perform the
following:
1. Install batteries and rollout tray.
2 . Service engine crankcase, fuel
e. Install bevel washers (50) with thick
tank, and radiator.
ends on top.
Section II. STOWAGE TOOL BOX
9-9.
GENERAL.
Refer to figure 9-2 and disassemble
the stowage tool box in the order of index
The stowage tool box is utilized for
n u m b e r s assigned.
storage of tools and miscellaneous equip-
ment required for generator set operation.
9-12
CLEANING.
The box consists of a hinged cover, seal,
and box. The cover covers the box opening
a. C l e a n seal with a clean lint-free
and the seal prevents moisture and dirt
cloth.
entering the box.
9-10. REMOVAL.
Cleaning Solvents are flammable and
Refer to figure 9-1 and remove stow-
moderately toxic to skin, eyes and
age tool box from base by removing screws
respiratory tract. Eye and skin
(16), nuts (17), and washers (18).
protection required. Good general
vent ilat ion is normally adequate.
b. Clean metal parts in an approved
9-11. DISASSEMBLY
cleaning solvent and dry thoroughly.
9-4
Change 8
