P-9-TM-457-35
T . O . 35C2-3-442-2
TM 5-6115-457-34
TM-07464A-35
Water pump group.
1.
r. Install hydraulic tank (precise sets
only) (paragraph 8-92).
Alternator assembly.
2.
Starter motor assembly.
3.
s. Install oil cooler group (para-
graph 8-84).
Turbocharger group.
4.
t. Install fuel pump group (para-
Day tank assembly.
5.
graph 8-68).
Manual throttle control.
6.
u. Install tachometer drive group
Lube oil filter group.
7.
v. Install fan mounting group (para-
Ether atomizer.
8.
graph 8-37).
Air cleaner assembly.
9.
w. Refer to Operator and Organiza-
tional Maintenance Manual and install the
10.
Engine wiring harness.
following:
ENGINE TEST AFTER OVERHAUL
Section XXXI.
a. PRE-RUN-IN CHECKS.
8-236. GENERAL.
Following a complete overhaul or
NOTE
any major repair, involving the installation
of piston rings, pistons, cylinder liners,
Rotate engine in a clockwise direc-
or bearings, the engine should be run-in
tion only, when viewing engine
prior to release for service.
from front.
NOTE
1. Manually rotate engine by apply-
Make sure all necessary adjust-
ing a 1-1/8 socket with extension handle to
ments have been performed and
crankshaft nut inside of damper.
engine is fully serviced before
starting test.
2. Hold manual fuel shutdown lever
8-237. ENGINE ASSEMBLY RUN-IN AND
in the closed rack or off position (fig-
ADJUSTMENTS.
ure 8-66).
Connect engine assembly to a suita-
CAUTION
ble engine dynamometer equipped with a
cooling system and means of monitoring
Do not crank starter motor for a
engine oil pressure, coolant temperature,
period of more than 15 seconds.
and engine RPM.
8-146
