P-8-627-34
T O 35C2-3-442-2
T M 5-6115-457-34
TM-07464A-35
Legend to figure 8 - 6 4 :
Plug (5)
1.
Bolt (3)
18.
Cap (6)
35.
2.
Bolt (8)
19.
Lock
Bolt (2)
36.
Lock washer (8)
20.
Bolt (3)
3.
Washer (2)
37.
Cover
21.
4.
Lock
38.
Cap
Gasket
22.
Plug (2)
Front plate
5.
39.
23.
Plug
6.
Gasket
40.
Bearing
24.
Washer
7.
Plug
41.
Dowel (2)
25.
Plug
8.
Bolt (2)
Stud
42.
26.
Lock washer (2)
Cap assembly
9.
Dowel (2)
43.
Bolt (3)
10.
27.
Flange
Dowel (2)
44.
Lock washer (3)
11.
28.
Gasket
45.
Bearing
Washer (3)
29.
12.
Liner (6)
Plug (2)
46.
Pipe
30.
13.
Seal (12)
Dowel
47.
Gasket
14.
31.
Orifice (6)
Dowel
48.
Cylinder block assembly
15.
32.
Plug
49.
Ball
Bolt (12)
33.
16.
Dowel (2)
50.
Plug
Washer (12)
17.
34.
Block
Plug
51.
to the face of the cylinder block (12, fig-
u r e 8-64). Liner projection must be
50 foot-pounds torque.
0.002 to 0.005 of an inch.
e. Using a suitable depth micrometer,
f. Cylinder block (51) may be pressure
m e a s u r e cylinder liner (12) projection
tested as follows:
by measuring down from liner surface
1. Seal off water inlet and outlet
holes air tight, using plates and suitable
rubber gaskets held in place by bolts.
2. Immerse cylinder block (51) i n
tank of water. Attach a suitable fitting at
one of the water inlet or outlet openings.
Apply 60 psi air pressure to water pocket
and observe water in tank for bubbles
indicating cracks or leaks.
WARNING
Compressed air used for cleaning and
drying purposes can create airborne
particles that may enter the eyes.
Pressure shall not exceed 30 psig.
Eye protection is required.
out passages with dry, compressed air.
g. Install camshaft bearings using a
Figure 8-65.
suitable tool. Care must be taken to align
oil holes in bearings with oil holes in
figure 8-54)
c y l i n d e r block. The front camshaft
8-144
Change
8
