P-9-TM-457-35 T.O. 35C2-3-442-2
TM-07464A-35 TM 5-6115-457-34
CHAPTER 3
HOUSING AND LIFTING FRAME ASSEMBLY REPAIR INSTRUCTIONS
Section I. HOUSING FRAME
1. Disconnect negative battery cable.
3-1.
GENERAL.
2. Remove housing panels and doors.
a. HOUSING FRAME. The housing
frame reinforces the housing panels and
3. Remove DC control circuit
doors. It provides interconnection between
breaker.
the lifting frame and front and rear housings.
4. Disconnect parallel receptacle
harness from rear housing.
b. FRONT HOUSING. The front hous-
ing is the mounting frame for the generator
set radiator and shutter assembly. It also
5. Remove manual speed control.
provides a connection point for the engine
crankcase breather tube and slave recepta-
6. Remove kit control panels from
cle SR2.
rear housing, if installed.
c. REAR HOUSING. The rear housing
7. Remove slave receptacles from
provides a mount for the control cubicle,
front housing and receptacle mounting
fault locator panel, DC control cubicle,
panel.
convenience receptacle, sleeve and plate
assembly, parallel harness receptacles,
8. Remove radiator and shutter
manual speed control, and mounting open-
assembly.
ings for the controls of the generator set
optional kits which are covered by plates if
b. Remove control cubicle, as specified
the kits are not installed. It also contains
the air intake panel.
REMOVAL AND DISASSEMBLY.
3-2.
c. Remove fault locator panel from rear
housing by disconnecting harness from rear
Refer to figure 3-1 and remove and
of locator panel and removing four screws
disassemble the housing frame in the order
attaching panel to rear housing.
of index numbers assigned. Pay particular
attention to the following:
d. Remove convenience receptacle
assembly from rear housing by disconnect-
ing harness from rear of assembly and re-
a. Refer to Operator and Organizational
moving six screws and washer securing
Maintenance Manual and perform the follow-
assembly to rear housing.
ing:
3-1
