P-9-TM-457-35
T.O. 35C2-3-442-2
TM-07464A-35 TM 5-6115-457-34
Figure 2-1. Specially designed tools (fabricated)
(sheet 3 of 3)
Section II. TROUBLESHOOTING
Malfunctions which may occur are listed in
2-4.
GENERAL.
This section provides information
lowed by a list of probable causes of the
useful in diagnosing and correcting unsatis-
trouble. The corrective action recom-
factory operation or failure of the engine
mended is described opposite the probable
generator sets and their components.
cause.
Section III. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
AND AUXILIARIES
2-5.
GENERAL.
1. Disconnect harness from control
cubicle.
This section contains instructions
2. Disconnect control cubicle from
for the removal and installation of major
rear housing by removing screws and
components of the generator set to facili- -
washers. Remove control cubicle.
tate repair and overhaul. Detailed mainte-
nance procedures for these components are
b. Installation. Refer to figure 2-2 and
contained in subsequent sections of this
install control cubicle as follows:
technical manual.
1. Install control cubicle in rear
2-6.
CONTROL CUBICLE.
housing and secure with screws and washers.
2. Connect electrical harness to
a. Removal. Refer to figure 2-2 and
control cubicle connector.
remove control cubicle as follows:
2-3
