P-9-TM-457-35
T.O. 35C2-3-442-2
TM-07464A-35
TM 5-6115-457-34
(a) Remove the existing
(a) Remove the existing
D3306(T) turbocharger exhaust elbow from
D3306(T) lube oil filler neck assembly from
the engine by removing the existing retain-
the engine by removing three bolts (106A),
ing clamp (85D).
three lockwashers (106B) and three washers
(106C). Make certain not to damage existing
(b) Install the salvaged
gasket (106E).
turbocharger exhaust elbow (85E) onto the
engine and secure with existing retaining
(b) Install the salvaged lube
clamp (85D). Make certain that water drain
oil filler neck assembly (106D) to the engine
plug points directly downward.
using the existing three bolts ( 106A), three
lockwashers (106 B), three washers (106C)
(4)
Oil Sump Shut-Off Valve.
and gasket (106 E).
Refer to figure 2-8 and install the salvaged
oil sump shut-off valve (85H), long nipple
(8)
Coolant Drain Valve. Refer
(85J), elbow (85G) and hose assembly (85F).
to figure 2-8 and install the salvaged coolant
drain valve (103C) as shown. Pay particular
(5)
Starter Motor. Refer to
attention to the following:
motor (85K) and attaching hardware in the
(a) Apply thread sealing
engine. Pay particular attention to the
compound conforming to Military Specification
following:
MIL-S-45180, type III to pipe threads prior to
installation.
(a) Reconnect tagged elec-
trical leads to the starter motor and
(b) Thread new reducer
bushing (106) into engine block.
(6)
Hydraulic Filter Assembly
(c) Assemble tee (104), plug
(MEP116A only). Refer to figure 2-8 and
(103) and elbow (105). Thread assembly into
install the salvaged hydraulic filter assem-
reducer bushing (106). Thread salvaged
bly (6A) ) as shown. Pay particular attention
coolant drain valve (103C) into tee (105) as
to the following:
shown.
(a) Assemble the hydraulic
filter bracket (6) to the salvaged filter
Fuel Filter and Pump Assem-
(9)
assembly (6A) using screws (4) and self-
bly. Refer to figure 2-8 and install the salva-
locking nuts (5).
ged fuel filter and pump assembly (102A) as
shown. Pay particular attention to the
(b) Remove existing hard-
following:
ware as shown and mount the hydraulic
filter assembly to the engine.
(a) Connect tagged electrical
leads and hoses.
(c) Connect elbows and
hose assemblies as shown.
(10) Alternator. Refer to figure
2-8 and install the salvaged alternator (99A)
Lube Oil Filler Neck
(7)
as shown. Pay particular attention to the
Assembly. Refer to figure 2-8 and install
following:
the saIvaged lube oil filler neck assembly
(a) Install new alternator fan
(106D). Pay particular attention to the
guard (99) using salvaged hardware.
following :
2-63
Change 4
