T . O . 35C2-3-442-2
P-9-TM-457-35
TM 5-6115-457-34
TM-07464A-35
(14) High Coolant Temperature
(11) Fan. Refer to figure 8-10
Switch. Refer to figure 2-8 and install the
and install the salvaged fan in the reverse
salvaged high coolant temperature switch
sequence of index numbers assigned.
(101D) as shown. Apply thread sealing com-
pound conforming to Military Specification
(12) Hydraulic Tank and
MIL-S-45180, type III to pipe threads prior to
Hydraulic Pump (ME P116A only).
installation.
(a) Refer to figure 2-8 and
(15) Coolant Temperature Trans-
remove the hydraulic tank mounting bracket
mitter. Refer to figure 2-8 and install the
from the salvaged hydraulic tank (97A).
salvaged coolant temperature transmitter
(101C) as shown. Apply thread sealing com-
(b) Install new mounting
pound conforming to Military Specification
bracket (97) onto the hydraulic tank (97A).
MIL-S-45180, type III, to pipe threads prior
to installation.
(c) Refer to figure 2-8 and
assemble the modified hydraulic tank (97A)
(16) Low Oil Pressure Switch. Re-
and the new hydraulic pump (98) onto the
fer to figure 2-8 and install the salvaged low
engine as follows:
oil pressure switch (101B) as shown. Apply
thread sealing compound conforming to Mili-
NOTE
tary Specification MIL-S-45180, type III to
pipe threads prior to installation.
Be sure hydraulic pump
gears mesh properly and
(17) Oil Pressure Transmitter.
there is no binding.
Refer to figure 2-8 and install the salvaged oil
pressure transmitter (101A) ) as shown. Apply
1. Apply thread seal-
thread sealing compound conforming to Mili-
ing compound conforming to Military Speci-
tary Specification MIL-S-45180, type III to
fication MIL-S-45180, type III to pipe
pipe threads prior to installation.
threads prior to installation.
(18) Over speed Switch. Refer to
2. Place hydraulic
pump (98) into pump receptacle, making
(107). Pay particular attention to the following:
certain that gear teeth mesh properly and do
not bind.
3. Place hydraulic
(a) Remove existing screws
tank (97A) onto pump and secure both
(107A) and washers (107B).
assemblies with existing hardware.
(b) Assemble the over speed
4. Attach fittings and
switch (107) to the over speed switch bracket
hoses.
(108) using screws (107C), washers (107D)
and nuts (107E).
(13) Alternator Belt and Fan
Belts. Refer to Operator and Organizational
(c) Install the overspeed
Maintenance Manual and install and adjust
shutdown switch onto the generator as shown.
the alternator belt and fan belts.
2-64
Change 4
