T.O. 35C2-3-442-2
P-9-TM-457-35
TM-07464A-35
TM 5-6115-457-34
Legend to figure 8-28:
1.
30. Impeller
clamp (2)
Nut (4)
16.
2.
31. Seal and spring assembly
Lock washer (4)
Hose
17.
3.
32. Ceramic
Cover
Nipple
18.
4.
ring
Gasket
Bolt (2)
19.
20.
5.
33. Seal ring
Lock washer (2)
Nut
6.
Tube assembly
21.
34. Bearing
Lock
7.
22.
35. Shaft
Gasket
Bearing
36. Seal
23.
8.
Plug
Gear
9.
37. Gasket
24.
Bolt
Nut (4)
10.
38. Housing assembly
25.
Washer
Lock (4)
11.
26.
Bolt
39. Stud (4)
Cage
12.
40. Stud (4)
27.
Washer
Cotter pin
13.
28.
Cover
41. F e r r u l e
Nut
14.
29.
42. Housing
Seal
Washer
15.
Seal
Section XVII. CRANKSHAFT PULLEY, DAMPER AND TIMING GEAR COVER GROUP
8-125.
GENERAL
f. Remove water pump group (para
8-118).
The crankshaft pulley is installed
on the front end of the engine crankshaft
g. Refer to Operator and Organiza-
and, by means of V-type drive belts, drives
tional Maintenance Manual and remove
the cooling fan pulley. The timing gear
cover is sealed to protect the timing gear
train, which consists of five gears located
h. Remove five bolts, washers and
at the front of the engine.
lockwashers securing oil pan to timing
g e a r cover.
8-126.
REMOVAL
i. Removal of the crankshaft pulley,
a. Remove engine assembly (para 2-8).
damper and timing gear cover group is
accomplished during disassembly (para
b. Remove fan mounting group (para
8-127).
8-31).
DISASSEMBLY
8-127.
c. Remove hydraulic tank (precise sets
only) (para 8-86).
Refer to figure 8-29, and disas-
d. Remove hydraulic pump (precise
semble crankshaft pulley, damper and tim-
sets only) (para 8-94).
ing gear cover group in the order of index
numbers assigned. Pay particular atten-
e. Remove hydraulic pump drive group
tion to the following:
8-65
