TO
35C2-3-442-2
P-8-627-34
TM-07464A-35
TM 5-6115-457-34
Legend to figure 8-29:
1. Bolt (6)
28.
Lock
Washer
2.
Washer (6)
29.
3.
Damper
30.
Bolt
4.
Bolt
Nut
31.
5.
Washer
32.
Lock washer
6.
Pulley
33.
Washer
7.
Bolt (2)
34.
Bolt
8.
35.
Lock washer (2)
Lock washer (2)
9.
36.
Cap
Washer (2)
10.
37.
Shim (12)
Nut
11.
38.
Shim (2)
Bolt
12.
39.
Bolt (3)
Nut
13.
40.
Lock washer (3)
Lock washer
14.
41.
Bolt (5)
Washer
15.
42.
Lock washer (5)
Bolt (2)
16.
43.
Bolt
Lock washer (2)
17.
Nut
44.
Washer (2)
18.
Lock washer
45.
Bolt
19.
Trunnion assembly
46.
Lock washer
Bushing
20.
Washer
47.
Trunnion support
21.
48.
Bolt (2)
Nut (4)
22.
49.
Lock washer (2)
Lock washer (4)
23.
50.
Lock washer (2)
24.
Seal
51.
Cover
25.
Gasket
52.
Cover
Stud
26.
53.
Gasket
27,
Bolt
Crankshaft gear, Section XXIX, Par 8-220
a. Remove bolts (1) from face of
vibration damper (3) and separate damper
e. If it is necessary to remove one of
from pulley (3).
the timing gears, bar engine over manually
b. After removing bolt (4), use a suit-
to bring all timing marks in line as shown
able puller and remove crankshaft pulley
in figure 8-30, before removing a gear.
(6).
WARNING
c. Separate top half of trunnion (9) and
retain shims (10 and 11) if present, for
Cleaning Solvents are flammable and
reuse.
moderately toxic to skin, eyes and
d. Since the accessory drive gear,
respiratory tract. Eye and skin
camshaft gear, crankshaft gear and oil
protect ion required. Good general
ventilation is normally adequate.
pump gears are covered under separate
sections that deal with these gears as part
Compressed air used for cleaning and
of other assemblies, their removal, clean-
drying purposes can create airborne
particles that may enter the eyes.
ing and inspection are covered in the
Pressure shall not exceed 30 psig.
following sections.
Eye protection is required.
Accessory drive gear, Section XX,
8-128. CLEANING
Par 8-150
Clean all parts in approved solvent
Oil pump gears, Section XXIII, Par 8-172
and dry using compressed air or a lint free
Camshaft gear, Section XXVII, Par 8-204
8-67
Change 8
