T O 35C2-3-442-2
P-8-627-34
TM 5-6115-457-34
TM-07464A-35
e. Discard seal and gasket.
cloth. Remove rust from pulley groove
using a stiff wire brush.
8-130. REPAIR.
8-129. INSPECTION
a. Remove minor nicks and burrs using
a. Inspect threaded parts for thread
a suitable file or hone.
damage,
b. Repair minor thread damage using
b. Inspect crankshaft pulley for cracks
a suitable thread chaser.
and worn grooves. Replace defective
pulley.
c. Remove rough edges on pulley
grooves with a small hand file.
Inspect timing gear cover for cracks,
c.
burred or nicked gasket surfaces. Replace
8-131. REASSEMBLY
cracked timing gear cover.
Refer to figure 8-29, and reas-
d. Check trunnion and trunnion support
semble crankshaft pulley, damper and
for flat spots and rough or grooved surfaces.
Alignment of timing marks
Figure 8-30.
8-68
Change 8
