TM 5-6115-584-12
NAVFAC P-8-622-12
TO-35C2-3-456-1
TM-05682C-12
1. Cable
6, Battery (2)
2. Connecter (2)
11. Terminal
7. Nut (4)
12. Bottom frame
3. Cable
8. Washer (4)
13. Tray
4. Jumper
9. Bolt (4)
14. Screw (4)
5. Top frame (2)
10. Terminal
15. Washer (4)
16. Battery terminal cover (4)
Figure 3-2. Battery Assembly
b.
Clean.
(1) Clean terminal connectors, (2), (4), (10) and (11),
batteries (6) and frame using a low sodium solution and wipe dry
with a clean cloth. Notify higher level of maintenance if terminals,
cables, batteries or frame is damaged.
c.
Service.
NOTE
The 6TN and 6TL batteries can be mixed or
matched. However, maintenance-free batteries
cannot be mixed or matched with military
batteries. The 6TN and 6TL batteries will perform
properly in bot weather as long as electrolyte levels
are carefully monitored. If the electrolyte expands
and causes the level to rise, some fluid must be
removed. If tbe level becomes too low due to
evaporation, distilled water may be used to obtain
the proper level. A good grade of drinking water
(excluding mineral water) may be used if distilled
water is not available.
3/8 inch above top of plates. Check that battery caps are not loose.
Electrolyte (NSNs
6810-00-249-9354 and
6810-00-843-1640) have a specific gravity of 1.280
and should be used in these batteries. Do NOT
adjust the electrolyte in wet batteries to a lower
specific gravity.
(1) Fill batteries (6) with clean distilled water to a level
of 3/8 inch above top of plates. In freezing weather, run engine a
minimum of one hour after adding water.
3-12.
GROUND ROD AND FUEL DRUM ADATPER
HOLD-DOWN ASSEMBLY.
a. Removal (see figure 3-9). On ASK equipped generators,
remove oil acess door and fuel filter acess door and perform the
following procedures.
(1) Ground Rod and Fuel Drum Adapter. Loosen
screws (1) and lockwashers (2). Slide three piece ground rod (3)
out of hold-down assembly (4), then slide out fuel drum adapter
(5).
(2)
Hold-down adapter. Grasp hold-down assembly
(4) and remove screw (1) and lockwasher (2). Remove hold-down
assembly.
Change 8
3-9
