TM 5-6115-465-34
TO 35C2-3-446-2
NAVFAC P-8-625-34
TM 06858B/06859D-34
CHAPTER 2
GENERAL MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
2-1. TOOLS AND SUPPORT EQUIPMENT.
2-2.
DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT
MAINTENANCE REPAIR PARTS.
There are no special tools or support equipment
required to perform any level of maintenance on
Direct support, general support and depot main-
generator set Models MEP-005A, MEP-104A, and
tenance repair parts are listed and illustrated in
the Organizational, Intermediate (Field) (Direct and
MEP-114A. Table 2-1 contains a list of recommended
General Support) and Depot Maintenance Repair Parts
tools and support equipment normally required to
and Special Tools List).
maintain the generator sets at the intermediate
(field) (direct and general support) and depot
2-3.
FABRICATED TOOLS AND EQUIPMENT.
maintenance levels. References or illustrations
indicating the need or use of these or similar
A breakout cable is required to troubleshoot the
tools-are as listed in the table.
electric governor system of MEP-114A. The break-
out cable-is used to gain access to the Governor
Control Unit's MS3106R2O-29 connector. Figure
2-O gives fabrication instructions for the break-
out cable.
Table 2-1.
TOOLS AND SUPPORT EQUIPMENT
Reference
FSN or Part No.
Item
Use
Para.
Figure
Torch outfit, cutting
3433-357-6311 or equal
Removing extensively damaged housing
and welding (Tool
components
Set L/W67706)
6625-643-1740 or equal
Testing voltage regulators
Hoist, chain, 3 ton
3950-292-9879 or equal
Removing and Installing engine and
generator assembles
Trestle, host,
Removing and installing engine and
3950-449-7005 or equal
portable, 5 ton
generator assembles
Multimeter, spilt core
6625-892-1497 or equal
Testing resistance of generator assem-
bly windings
Mutimeter,
digtal
Troubleshooting the electric governor
MEP 114A only
6625-581-2466 or equal
Testing continuity of generator assem-
bly components
Puller attachment
5180-711-6753 or equal
Removing generator bearing.
(conponentof puller
kit 5180-701-8046)
Solder outfit, electric
Soldering electrical leads to generator
3439-853-8760 or equal
assembly rectifiers
Test stand, actuator
Testing performance of hydraulic
4940-152-2107 or equal
actuator
4910-774-9343 or equal
Testing hydraulic pump assembly
Test gauge and hose
assy
Testing speed switch elements trip
6680-892-1510 or equal
speed
stroboscopic
Test stand, ignition
Testing of speed switch
4910-912-3960 or equal
magneto
2-1
Change 5
