TM5-6115-465-34
NAVFAC P-8-625-34
T . O . 35C2-3-446-2
TM 06858B/06859D-34
CHAPTER 6
ENCLOSURE ASSEMBLY REPAIR INSTRUCTIONS
Section I.
HOUSING ASSEMBLY
b.
Cleaning, Inspection, and Repair.
6-1.
GENERAL.
(1) Clean relay table parts in dry cleaning
The housing assembly fully encloses the top,
sides, and ends of the generator set. It consists of
solvent (Federal Specification P-D-680) and dry
thoroughly.
doors, covers, panels and supports. All openings
into the interior of the generator set are equipped
(2) Inspect relay table for breaks, cracks,
with sealing doors which prevent the entry of
and other damage.
foreign material when the doors are closed.
(3) Check all parts for defective paint.
6-2.
RELAY TABLE MAINTENANCE.
(4) Check all threads for crossing, stripping,
a.
Removal.
and peening.
(1) Refer to the Operator and Organizational
(5) Repair cracks, breaks, and defective
Maintenance Manual and remove housing assembly
welds by welding.
doors, covers, and panels.
(6) Replace any parts damaged beyond repair.
(2) Remove relay tables by following the as-
cending sequence of index num'hers (1 through 36)
(7) Remove defective paint and corrosion.
assigned to figure 6-1.1.
Treat and paint in accordance with service require-
ments.
c. Installation.
NOTE
(1) Install relay table in reverse order of re-
moval procedures.
It is not necessaryto completely dis-
assemble the relay table to replace a
(2) Refer to the Operator and Organizational
single part, Only those parts requiring
Maintenance Manual and install housing assembly
repair or replacement need be removed.
doors, covers, and panels.
Section II.
LIFTING FRAME
6-3.
(2) Remove hydraulic sump (paragraph 3-40).
GENERAL.
The lifting frame is securely attached to the skid
(3) Remove fuel lines and fittings (paragraph
3-22) and day tank assembly (paragraph 3- 18).
base. It is equipped with lifting-clevises at the top
of each side for lifting equipment attachment. In
(4) Remove main fuel tank filler neck (para-
addition, the lifting frame provides support for the
graph 3-15).
center of the housing assembly and serves as a
mounting point for the hydraulic sump and the day
(5) Remove lifting frame components by follow-
tank assembly. During generator assembly removal,
the lifting frame provides support for the rear of the
ing the sequence of ascending index numbers (1
engine assembly.
through 26) assigned to figure 6-2.
6-4.
NOTE
LIFTING FRAME MAINTENANCE.
a.
Removal.
It is not necessary to completely disassem-
ble the lifting frame to replace a single
(1) Remove housing assembly doors and pan-
part. Only those parts requiring repair or
els as required for lifting frame removal (paragraph
replacement need be removed.
6-2 ).
Change 2
6-1
