TM 9-6115-668-13
3.
Remove bolt (69), with serrated lock washer (68), washer (67), and closure plate (66).
4.
Install long eyebolt (65) in diesel engine block (64).
5.
Install short eyebolt (63) in diesel engine block (64).
6.
Install lifting device in eyebolts (63, 65).
7.
Remove two bolts (34) and two serrated lock washers (35).
8.
Lift diesel engine (64) enough to take the weight off shock absorbers (41).
9.
Remove four bolts (37), four serrated lock washers (38), and four washers (39).
10. Remove two shock absorber plates (40).
11. Remove two bolts (44), two serrated lock washers (43), and two washers (42) from two shock ab-
sorbers (41).
12. Remove two shock absorbers (41).
N O T E
It Is not necessary to install suitablespacing material or remove lifting
device if shock absorber is to be replaced immediately.
13. Install suitable spacing material between bracket (72) and engine mount (36).
C A U T I O N
Use Loctite 243 on bolts.
Tighten bolts to torque values in table (item G.1, appendix G)
N O T E
For easier positioning of components coat mating surfaces with lubri-
cant.
1.
If necessary install lifting device in eyebolts (63, 65).
2.
Lift diesel engine (64) enough to allow spacing material to be removed if installed.
3.
Install two shock absorbers (41) on two brackets (72) and secure with two bolts (44), two serrated
lock washers (43), and two washers (42).
4.
Install two shock absorber plates (40) on shock absorbers (41) and secure with four bolts (37), four
serrated lock washers (38), and four washers (39).
5.
Lower engine until weight has been transfered to shock absorbers (41).
6.
Install two bolts (34) and two serrated lock washers (35) on mounts (36) and shock absorbers (41).
7.
Remove lifting device (73) and eyebolts (63, 65).
8.
Install ciosure plate (66) and secure with bolt (69), serrated lock washer (68), and washer (67).
9.
Install upper part of partition (4) as instructed in paragraph 5.47, steps 22 through 24.
10. Install unit hood assembly (1) as instructed in paragraph 4.14.
5 - 2 1 9