TM 9-6115-668-13
5.48
DIESEL ENGINE SHOCK ABSORBERS MAINTENANCE.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Tool Kit
(item 2, appendix B)
Automotive Fuel and Electrical System Repair, Tool Kit
(item 3, appendix B)
Eyebolts
(item 17, 18 appendix B)
Reference
Generator Set 150 kW shut
down
paragraph 2.5.2
Materials/Parts
Loctite 243
(item 16, appendix E)
Lubricant
(item 6, appendix E)
Personal required
Two - Three
Disconnect the negative battery cable first and then the positive battery termi-
nal cables. Failure to observe this warning could result in severe personal injury
or death.
Engine and generator shock mounts are not repairable. Do not attempt to
disassemble. Failure to comply may cause injury or death.
Do not stand in the operating area of the crane or forklift. Failure to observe
these warnings could result in severe personal injury or death.
Engine should be lifted only far enough so that the engine mount can be
removed. Equipment will be damaged if the engine is lifted too high.
Suitable spacing must be provided when engine shock absorbers are re-
moved. Failure to provide proper support to the engine will cause damage to
the equipment. The engine must be supported on the engine mounts.
1.
Remove unit hood assembly (1, figure 5-52) as instructed in paragraph 4.14.
2. Remove upper part of partition (4) as instructed in paragraph 5.47, steps 3 through 6.
5-218
