TM 9-6115-668-13
C A U T I O N
Clean up ail oil leaks.
Do not damage fuel lines, oil lines, or cables.
Tag all cables prior to removal to ensure correct connection of the
cables during installation.
Bag ail fuel and oil lines with plastic bags and secure with rubber
bands to prevent contamination.
Do not sit engine on oil pan. Blocking must be used to support the
engine and generator on mounts.
1.
Remove unit hood assembly (1, figure 5-52, sheet 1 of 2) as instructed in paragraph 4.14.
2.
Remove battery set (2) as instructed in paragraph 4.74.
3.
Remove air filter housing and piping (3) as instructed in paragraph 5.27.
4.
Remove rubber seal (5) from lower part (6) of partition.
5.
Remove four nuts (7), four serrated lock washers (8), and four washers (9) from threaded pins (10).
6.
Remove upper part (4) of partition.
7.
Remove control cabinet unit (11) as instructed in paragraph 4.43.
8.
Remove generator wiring harness (12) as instructed in paragraph 5.46.
N O T E
Leave EHG regulator N7 on diesel engine.
9.
Remove EHG regulator N7 (13) as instructed in paragraph 4.76. Coil up cable and secure to diesel
engine (28) together with EHG controller N7 (13).
10. Remove fuel lines (14) as instructed in paragraph 4.42 and tie up to fuel tank (31).
11. Loosen clamp (16) and remove air hose (15).
12. Loosen clamps (19, 21) and remove air hose (18). Retain clamps (19, 21).
13. Remove exhaust manifold (23) from heating unit (24) as instructed in paragraph 5.31.
14. Remove filter cup (25, 26) as instructed in paragraph 4.33.
15. Remove oil hoses (27) from heat exchanger box (22) and diesel engine (28) as instructed in para-
graph 5.38.
16. Remove subcurrent filter oil lines (29) from diesel engine (28) as instructed in paragraph 5.29.
17. Remove exhaust pipes with header (30) from diesel engine (28) as instructed in paragraphs 4.82
and 4.83.
18. Remove pickup cable (32) as instructed in paragraph 5.44.
19. Remove actuator cable (33) as instructed in paragraph 5.42.
20. Screw long eyebolt (65) into engine block of diesel engine (64).
21. Remove bolt (69), washer (67), serrated lock washer (68) and closure plate (66).
5 - 2 1 5
