TM 5-6115-593-34 NAVFAC P-8-631-34 TO-35C2-3-463-2 (2) Test. (a) With  the  bleeder  valve  closed  and the shut-off valve in the oil pressure line  open,  start  and  operate  the  set at rated speed (use the set instrumentation) and at no load. (b) Open  the  bleeder  valve  slightly  to purge air from the system. (c) Close the bleeder valve and record the oil pressure as indicated on the external gauge. (d) Almost completely close the shut-off valve. (e) Slowly  open  the  bleeder  valve  until the     low     oil     pressure     protective device     shuts     down     the     engine. Record     the     reading     of     the     oil pressure  gauge  at  the  point  of  set shutdown (see figure 515.1-II). (f) Record operation of the malfunction indicator light. (g) Repeat     (a)     through     (f)     for     the warning switch. d. Results.        Compare    the    value    of    shutdown pressure with the requirement of table 16-1. 16-22.    OVERTEMPERATURE  PROTECTIVE  DEVICE TEST. a. General.  The overtemperature device must be capable   of   protecting   the   engine   in   the   set against overheating for any reason. b. Apparatus.    Instrumentation  for  measuring  load conditions   and   set   and   ambient   temperatures shall   be   as   described   and   illustrated   in   MIL- HDBK-705, Method 205.1, paragraph 205.1.10. c. Procedure. (1) Preparation for test. (a) Connect the load instrumentation in accordance with the applicable figure    of    MIL-HDBK-705,    Method 205.1, paragraph 205.1.10. (b) Install  a  thermocouple  to  measure the  same  temperature  as  seen  by the protective device sensor. (2) Test. (a) Start  and  operate  the  generator  set at   rated   voltage,   rated   frequency (speed), and rated load. (b) Block the cooling air to the generator set or manually trip overload    sensors    on    fan    motor contactor,  located  in  the  2c  central box. (c) Continuously   monitor   the   temper- ature    seen    by    the    thermocouple installed  in  paragraph  16-22c(1)(b) above.    Record  the  temperature  at which the overtemperature protective device actuates.  Record the temperature at which the coolant temperature indicator illuminates. CAUTION If   the   engine   fails   to   shutdown when the temperature exceeds the maximum   trip   value   specified   in table     16-1,     the     test     shall     be immediately discontinued. d. Results.    Compare  the  results  with  the  require- ments of table 16-1. 16-23.  PHASE SEQUENCE TEST (ROTATION) a. General.  Unless the phase sequence (rotation) of the load 16-19