Figure 4-31. Replacing Oil Pressure Gauge

Figure 4-30. Oil Filter Assembly - TM-5-6115-584-12_137

TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
94

TM 5-6115-584.12 NAVFAC P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 Figure 4-31. Replacing Oil Pressure Gauge 4-33. OIL PRESSURE GAUGE. Iockwasher (9), clamp (4) and remove oil Pressure gauge and bracket. Remove fitting (5) and nuts (6) attaching On ASK equipped generators, remove oil access door. gauge (7) to mounting bracket (8) and remove gauge (7). a. Test. Attach a pressure gauge of known accuracy between flexible oil line and unit pressure gauge. Operate unit for 1/2 hour and check that both gauges read the same. At rated RPM the normal oil pressure is 20 to 45 PSI which is dependent on air and engine temperature, grads of oil, and wear tolerance of engine. If the unit pressure gauge is in error by more than 5 Ibs, replace. c. Replace. Install oil pressure gauge (7) on mounting bracket (8) with nuts (6) two on each side of bracket (8). Maintain gap between gauge and bracket as indicated on figure 4-31. Position oil pressure gauge and bracket on engine and install clamp (4), lockwasher (3) and screw (2). Connect and tighten oil line (1). b. Remove (see figure 4-31). Disconnect and drain oil Iine (1) top oil pressure gauge (7), Remove screw (2), Change 7 4-37

Privacy Statement
Press Release
Contact