Figure 4-30. Oil Filter Assembly - TM-5-6115-584-12

Figure 4-31. Replacing Oil Pressure Gauge - TM-5-6115-584-12_138

TM-5-6115-584-12 Generator Set Diesel Engine Driven Tactical Skid Mtd. 30 Kw 3 Phase 4 Wire 120/208 and 240/416 Volts Manual
Page Navigation
93

Figure 4-30. Oil Filter Assembly TM 5-6115-584-12 NAVFAC P-8-622-12 TO-35C2-3-456-1 TM-05682C-12 d. Install. Install switch (11) in adapter (5) and b. Remove. Drain oil filter into suitable container tighten. Use wrench on square portion of switch base. by removing drain plug (1). Loosen through bolt (2) Connect leads at terminals 1 and 2. and remove body (3). Remove and discard filter (6) and gasket (4). 4-32. OIL FILTER. On ASK equipped generators, remove oil access door. c. Replace. Clean filter mounting area in adapter (5) and inside of body (3). Install new element (6) in body (3). Install new a. Service (see figure 4-30). Every 100 operating hours gasket (4) In groove of adapter (5). Position body (3) (drain down) replace oil filter element. Clean inside of bowl while filter is with element Installed on adapter (6) and secure with through bolt removed. Replace defective hoses . (2). Tighten through bolt 10 to 15 ft-lb. 4-36 Change 7

Privacy Statement
Press Release
Contact