TM 5-6115-465-12
TO 35C2-3-446-1
NAVFAC P-8-625-12
TM 06858B/06859D-12
26.
Coolant hose assembly
1.
Clamp
27.
Elbow
2.
Exhaust pipe
28.
Elbow
3.
Rain cap
29.
Coolant hose assembly
4.
Heater assembly
30.
Street elbow
5.
Screw
31.
Tee
6.
Flat washer
32.
Pipe nipple
7.
Lock washer
33.
Valve
8.
Nut
34.
Elbow
9.
Heater control assembly
35.
Elbow
10.
Screw & captive washer assembly
36.
Fuel hose assembly
11.
Nut
37.
Thermostat switch
12.
Elbow, 45 degree
38.
Wiring harness
13.
Adapter
39.
Clamp
14.
Valve
40.
Screw & captive washer assembly
15.
Elbow
41.
Nut
16.
Adapter
42.
Wiring harness
17.
Coolant hose assembly
43.
Protective cover
18.
Pipe nipple
44.
Plug "WATER"
19.
Valve
45.
Plug
20.
Elbow
46.
Plug
21.
Pipe nipple
47.
Plug
22.
Tee
48.
Plate
23.
Adapter
49.
Cap
24.
Pressure relief valve
ME 5-6115-465-12/4-1 (2)
50.
Cover
25.
Elbow
Fuel Burning Winterization Kit Installation (Sheet 2 of 2)
Figure 4-1.
b. Replacement.
(10) Disconnect fuel line and remove elbow
from fuel solenoid valve (paragraph 3-75).
(1) Removal.
(11) Install fuel burning winterization kit
(a) Refer to paragraph 3-31 and drain the
following the ascending sequence of index numbers
engine cooling system.
(1 through 50) assigned to figure 4-1.
(b) Remove fuel burning winterization kit
in reverse order of steps (2) through (14) in para-
NOTE
graph 4-4a. above.
Run wiring harnesses through existing
(c) Refer to paragraph 3-31 and service
clamps (39) as shown.
the engine cooling system with the proper coolant.
(2) Installation. Refer to paragraph 4-4a.
(12) Install elbow removed in step (10) above
above for installation procedures.
and connect fuel line.
(13) Fill cooling system with proper coolant
PREVENTIVE MAINTENANCE CHECKS AND
SERVICES.
(14) Install heater assembly protective cover
a. General. To insure that the fuel burning
winterization kit is ready for operation at all times,
it must be systematically inspected in order that de-
(15) Loosen coolant hose(17, figure 4-1) at
fects be discovered and corrected before serious
water pump assembly and open valve (19) to bleed air
damage or failure of the equipment results. Defects
from heater assembly and coolant lines.
discovered during operation shall be noted for cor-
rection as soon as operation ceases. Operation shall
(16) Tighten coolant line and close valve.
be ceased immediately if a defect which may cause
damage to the equipment is noted. All defects and
(17) Add coolant to radiator as necessary.
short comings shall be recorded, together with the
