TM 5-6115-465-12
TO 35C2-3-446-1
NAVFAC P-8-625-12
TM 06858B/06859D-12
TOOL STOWAGE BOX
Section XIX.
b. Inspection and Cleaning.
GENERAL.
A tool stowage box is provided on the left side of
(1) Inspect the tool box for damaged hinge o r
the generator set (figure 1-2). The generator access
fastener, dents, corrosion, and deterioration of
door must be opened to gain access to the tool box.
finish.
The dimensions of the tool box are 15.25" x 10.43"
x 6.12". The tool box has a hinged cover that is held
in the closed position by a single draw-pull fastener.
(2) Clean the tool box with an approved sol-
vent and dry thoroughly.
a. Removal.
c. Installation. Install the tool box by revers-
(1) Remove the hex nuts (1, figure 3-48), lock-
ing removal procedures.
washers (2) and capscrews (3) to remove the tool box.
ME 5-6115-465-12/3-48
Tool Stowage Box
