TM 5-6115-465-12
TO 35C2-3-446-1
NAVFAC P-8-625-12
TM 06858B/06859D-12
Fuel Burning Winterization Kit Heater Control Assembly Maintenance
(4) Installation. Install heater control as-
(b) Pull control assembly out from genera-
tor set and disconnect electrical connectors.
sembly in reverse order of removal procedures.
(2) Cleaning and Inspection.
b. Heater Assembly Operational Testing. Refer
to psragraph 2-22 and operate the heater assembly to
determine if heater is operational.
(a) Clean heater control assembly with
ftltered compressed air and an electrician's brush
or wipe with a clean, lint-free cloth lightly-moisten-
c. Regulator Valve Assembly Fuel Flow Check
ed with an approved solvent.
and Adjustment.
(b) Visually inspect heater control assem-
(1) Service regulator valve assembly screen,
bly for cracks, corrosion, bent or broken connector
sintered filter, and metering orifice assembly (para-
pins and other damage.
graph 4-7b. above). Do not install turner fuel line or
protective cover.
(c) Replace control assembly if damage is
noted.
(2) Tag and disconnect electrical lead to
igniter assembly (figure 4-4).
(3) Lamp Replacement.
(3) Remove screws and cover plate to expose
(a) Unscrew lens (figure 4-3).
brass adjusting screw.
(b) Depress lamp and rotate counterclock-
(4) Connect one end of burner fuel line onto
wise to remove from indicator light base.
metering orifice sssembly and position the other end
to drain into a graduated container.
(c) Insert replacement lamp into base. De-
press and rotate clockwise to lock in position.
(5) Install a jumper wire across terminals of
(d) Install lens.
thermostat switch (37, figure 4-1).
