TM 5-6115-465-12
TO 35C2-3-446-1
NAVFAC P-8-625-12
TM 06858B/06859D-12
37. Coolant hose assembly
1.
Bracket
38. Pipe adapter
2.
Bracket
39. Tee
3.
Bracket
40. Elbow
4.
Lockwasher
41. Adapter
5.
Screw
42. Pressure relief valve
6.
Bracket
43. Pipe adapter
7.
Bracket
44. Valve
8.
Lockwasher
45. Elbow
9.
Screw
46. Coolant hose assembly
10.
Pipe tee
47. Three-way valve
11.
48. Screw
12.
Pipe
49. Lockwasher
13.
Clamp
50. Nut
14.
Clamp
51. Street elbow, 45 degree
15.
Lockwasher
52. Elbow
16.
Nut
53. Tube cap
17.
Thermostat switch
54. Elbow
18.
Pump and motor assembly
55. Elbow
19.
Clamp
56. Coolant hose assembly
20.
Lockwasher
57. Elbow
21.
Nut
58. Reducer
22.
Heater control assembly
59. Elbow
23.
Lockwasher
60. Coolant hose assembly
24.
Screw
61. Wiring harness
25.
Reducer
62. Clamp
26.
Elbow
63. Screw & captive washer assembly
27.
Elbow
64. Nut
28.
Coolant hose assembly
65. Tubing
29.
Street elbow
66. Wiring harness
30.
Pipe coupling
67. Hose assembly
31.
Shutoff cock
68. Plug
32.
Street tee
69. Plug
33.
Straight adapter
70. Plug
34.
Tube cap
71. Cover plate
35.
Elbow
ME 5-6115-465-12/4-5 (2)
36.
Elbow
Figure 4-5.
Electric Winterization Kit Installation (Sheet 2 of 2)
(9) Slide shrink tubing (65) over all screw
NOTE
terminals and shrink.
Coat threads of all pipe fittings with seal-
(10) Loosen coolant hose assembly (28) at
ing compound conforming to Military Speci-
elbow (26). Place three way valve (47) in open posi-
fication MIL-S-22743, Grade HVV prior to
tion and open valves (31) and (44).
installation.
NOTE
ization kit.
Tube caps (34 and 53) are to be removed
and stored in the generator set tool box
(12) Tighten coolant hose assembly and close
and tee (32) and straight adapter (33) in-
valves.
stalled if fuel burning winterization kit is
to be installed.
(13) Add coolant to generator set cooling sys-
tem as necessary.
(7) Run wiring harness through existing
clamps (62) where indicated.
b.
Replacement.
(8) Connect external power wiring harness
(1) Removal.
to heater control assembly.
4-13