TM 9-6115-668-13
3.
Remove generator wiring harness (24) of diesel engine as instructed in paragraph 5.46.
4.
Remove EHG controller N7 (35) as instructed in paragraph 4.76 and secure to engine (3).
5.
Loosen clamps (4) and (5) and remove air pipes (2) on engine side of partition.
6. Tag fuel lines (37, 38) and remove from engine block.
7.
Tag fuel line (29) and remove from priming pump as instructed in paragraph 4.42.
8.
Cut cable ties holding fuel lines to engine (3) or other objects.
9. Remove filter cups (30, 31) as instructed in paragraph 4.33.
10.
Loosen clamp (11) and remove air hose (10) from battery charging generator (9).
11.
Remove screw (15), serrated lock washer (16), and washer (17).
12. Remove spacer (20) and washer (21).
NOTE
Clamp (N) is retained on hose (8)
13.
Loosen clamp (14) and remove air hose (19) and clamp (18) from elbow (13) on panel (12).
14.
Remove oil hose (25) from heat exchange box (23) as indicated in paragraph 5.39.
15.
Remove oil hoses (8) from engine (3) as instructed in paragraph 5.29.
16.
Remove exhaust pipes with header (28) as instructed in paragraph 4.82 and 4.83.
17.
Remove actuator cable (6) as instructed in paragraph 5.42.
18.
Remove pick-up cable (7) as instructed in paragraph 5.44.
19.
Remove bolt (43), serrated lock washer (44), washer (45) and closure plate (46).
20.
Install long eyebolt (41) on diesel engine block (42).
21.
Install short eyebolt (40) on diesel engine block (42).
22.
Install lifting device on eyebolts (40.41) and lift until there is no slack in the cables.
23.
Remove two bolts (47) two serrated lock washers (48) from engine mounts (49).
24.
Support synchronous generator (60) at intemediate flange (54) with suitable support (56 to 58).
25.
Remove eight bolts (51), eight serrated lock washers (52) and eight washers (53) from the diesel engine side of
intermediate flange (54).
26. Separate the diesel engine (42) from the intermediate flange (54) by installing two bolts (59) in threaded hole
(found above the mounting holes on the intermediate flange (54) on each side of engine).
27. Tighten bolts (59) evenly (on both sides of engine) until diesel engine (42) is disengaged from intermediate flange
(54).
28. Remove two bolts (59).
29. Lift diesel engine (42) off base (34).
30.
Support engine by placing suitable support under engine mounts and the clutch housing (55).
5-226