TM 9-6115-668-13
Use Loctitie 243 on bolts.
Tighten bolts to torque values In table (Item G.1, appendix G).
NOTE
For easier positioning of synchronous generator, apply assembly lubricant to
rubber seal on air guide box of synchronous generator, synchronous generator
shock absorbers, and rubber coupling element.
1.
Lift synchronous generator (14) off mounting blocks and place on shock absorbers (20).
Make sure that coupling elements do not jam when pushed together.
2.
Install synchronous generator (14) on diesel engine (3).
3.
Install eight bolts (27), eight serrated lock washers (26), and eight washers (25) into intermediate flange (13) and
screw into flywheel housing (28).
4.
Install two bolts (17), two serrated lock washers (18) and two washers (19) through synchronous generator mount
(21) and on shock absorbers (20). lighten bolts (17).
5.
Remove suport (22 to 24) from beneath flywheel housing (28) of diesel engine (3).
6.
Remove lifting device from lifting lug (16) on synchronous generator (14) and lifting lug (15) on intermediate flange
(13).
7.
Install control cabinet unit (2) as instructed in paragraph 4.43.
8.
Install upper part of partition (4) and secure with four washers (8) and four serrated lock washers (9) on studs (6).
9. Install rubber seal (5).
10.
Install air filter housing and piping (11) as instructed in paragraph 5.27.
11.
Install battery set (12) as instructed in paragraph 4.74.
12.
Install unit hood assembly (1) as instructed in paragraph 4.14.
13.
Connect load bank to generator set and perform procedures in paragraph 5.53.
Change 1
5-231
