TM 9-6115-668-13
5.52
CLUTCH ASSEMBLY MAINTENANCE.
This task covers:
a. Removal
INITIAL SETUP
Tools
b. Installation
General Mechanic’s Tool Kit
(item 2, appendix B)
Automotive Fuel and Electrical System Repair, Tool Kit
(item 3, appendix B)
Puller
(item 21, appendix B)
Load bank (item 19, appendix B)
Equipment Conditions
Reference
Generator Set 150 kW shut
down
paragraph 2.5.2
Materials/Parts
Loctite 243
(item 16, appendix E)
Lubricant
(item 6, appendix E)
Personnel required
Two
Disconnect the negative battery cable first and then the positive battery termi-
nal cables. Failure to observe this warning could result In severe personal Injury
or death.
1.
Remove unit hood assembly (1, figure 5-55) as instructed in paragraph 4.14.
2. Remove synchronous generator (2) as instructed in paragraph 5.51.
3.
Remove bolts (6), and serrated lock washers (5) from flywheel (4).
4. Remove driver ring (7) from flywheel (4).
5.
Remove tubber element (10) from clutch hub (16).
6.
7.
Remove bolt (11). serrated lock washer (12) and thrust washer (13) from shaft (14) of synchronous generator (2).
Remove eight bolts (8) and eight serrated lock washers (9).
Wear gloves and eye protection. Failure to observe this warning could result In
severe personal Injury or death.
NOTE
For easier removal of clutch hub, heat to approximately 212 °F (100 °C).
8. Remove dutch hub (16) with puller.
Change 1
5-233
