TM 9-6115-668-13
NOTE
Leave woodruff key on clutch hub.
1. Place clutch hub (16 on shaft (14).
CAUTION
Tighten bolts with torque wrench to torque values In table (item G.1, appendix G).
2. Install thrust washer (13) and serrated lock washer (12) and install bolt (11) in shaft (14).
3. Install rubber element (10) into clutch hub (16).
4. Install eight bolts (8) and eight serrated lock washers (9) into rubber element (10) on clutch hub (16).
5. Place driver ring (7) on flywheel (4) and secure with eight serrated lock washers (5) and eight bolts (6). lighten
bolts (6).
6. Install synchronous generator (2) as instructed in paragraph 5.51.
7. Install unit hood assembly (1) as instructed in paragraph 4.14.
8. Connect load bank to generator set and perform procedures in paragraph 5.53.
- -
5-234
Change 1
