TM 9-6115-668-13
15. Loosen clamp (63) and remove rubber hose (65) off elbow (62).
16. Loosen clamp (60) and remove elbow (62) out of rubber hose (61).
17. Loosen clamp (59) and remove rubber hose (61) off pipe (58).
18. Loosen clamp (57) and remove pipe (58) out of rubber hose (56).
19. Loosen clamp (55) and remove rubber hose (56) off turbocharger inlet.
INSTALLATION
N O T E
Before sliding rubber hoses onto pipes, elbows and T-junction, coat
insides with lubricant.
1.
Install rubber hose (56) and clamps (55, 57) on turbocharger inlet and tighten clamp (55).
2.
Install pipe (58) into rubber hose (56) and tighten clamp (57).
3.
Install rubber hose (61) and clamps (59, 61) on pipe (58) and tighten clamp (59).
4.
Install elbow (58) into rubber hose (61) and tighten clamp (60).
5.
Install rubber hose (65) and clamps (63, 64) on elbow (62) and tighten clamp (63). Do not tighten
clamp (64).
6.
Install T-junction (43) into rubber hose (40); do not tighten clamp (41).
7.
Install rubber hose (52) and clamps (53, 54) on turbocharger inlet and tighten clamp (54).
8.
Install pipe (51) into rubber hose (52) and tighten clamp (53).
9.
Install rubber hose (48) on pipe (51) and tighten clamp (50).
10. Install elbow (46) into rubber hose (48) and tighten clamp (49).
11. Install rubber hose (47) on elbow (46) and tighten clamp (45).
12. Install rubber hose (47) and clamps (45, 44) on T-junction (43); do not tighten clamp (44).
13. Install rubber hose (40) and clamps (41, 42) on T-junction (43) and tighten clamp (42).
14. Install elbow (39) into rubber hose (40) and tighten clamp (41).
15. Install rubber hose (36) and clamps (37, 38) on elbow (39) and tighten clamp (38).
16. Install connector piece of air filter housing (33) on rubber hose (36) and place on (33); tighten clamp
(37).
17. Install two screws (32), two washers (31), and two spacers (30), two washers (29), two serrated
lock washers (28) and two nuts (27).
C A U T I O N
Align air filter housing and piping so that elbow (39) does not contact gen-
erator lifting eye.
18. Tighten clamps (64, 44).
19. Install plug connector 2J6 with cable (35) on service switch (34).
20. Install unit hood assembly (1) as instructed in paragraph 4.14.
5-166
