TM 9-6115-668-13
INSTALLATION
1.
Install screw (10) with new seal (11) in subcurrent filter (5).
2.
Install hollow screw (9) with new seals (8,6) and oil line (7) on subcurrent filter (5).
3.
Install hollow screw (27), new seals (25,26) and oil line (7) in adapter (24)
4.
Install hollow screw (15) with new seals (12, 14) and oil line (13) on subcurrent filter (5).
5.
Install hollow screw (23) with new seals (22, 21) and oil line (13) in adapter (20).
6.
Install screws (3), washers (4), and subcurrent filter (5) on bracket (16).
7.
Install nuts (19) serrated lock washers (18), and washers (17) on screws (3) and tighten.
8.
Install new cable ties, bundle cable ties (28, 29).
9.
Close flap (2).
N O T E
If hollow screws (9,15,23, and 27) and screw (10) were installed to pre-
vent contamination, remove prior to beginning installation proce-
dure. If plastic bags were installed on oil lines, remove prior to begin-
ning installation procedure.
5-169
