5.27 AIR FILTER HOUSING AND PIPING MAINTENANCE.

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
493

TM 9-6115-668-13 5.27 AIR FILTER HOUSING AND PIPING MAINTENANCE. This task covers: a. Removal b. Installation INITIAL SETUP Tools Equipment Conditions General Mechanic’s Tool Kit Reference (item 2, appendix B) Generator Set 150 kW Automotive Fuel and Electrical System Repair, Tool Kit shut down, (item 3, appendix B) paragraph 2.5.2 Materials/Parts Lubricant (item 6, appendix E) WARNING Disconnect the negative battery cable first and then the positive bat- tery terminal cables. Failure to observe this warning could result in se- vere personal injury or death. CAUTION Tag all cables prior to removal to ensure correct connection of the cables during installation. REMOVAL 1. Remove unit hood assembly (1, figure 5-40) as instructed in paragraph 4.14. 2. Remove plug connector 2J6 with cable (35) from service switch (34). 3. Remove two nuts (27), two serrated lock washers (28), two washers (29), two spacer (30), two washers (31), and two screws (32). 4. Loosen clamp (37) and remove air filter housing (33) from rubber hose (36). 5. Loosen clamp (38) and remove rubber hose (36) off elbow (39). 6. Loosen clamp (41) and remove elbow (39) out of rubber hose (40). 7. Loosen clamp (42) and remove rubber hose (40) off T-junction (43). 8. Loosen clamp (64) and remove T-junction (43) out of rubber hose (65). 9. Loosen clamp (44) and remove T-junction (43) out of rubber hose (47). 10. Loosen clamp (45) and remove rubber hose (47) off elbow (46). 11. Loosen clamp (49) and remove elbow (46) out of rubber hose (48). 12. Loosen clamp (50) and remove rubber hose (48) off pipe (51). 13. Loosen clamp (53) and remove pipe (51) out of rubber hose (52). 14. Loosen clamp (54) and remove rubber hose (52) off turbocharger inlet. 5-165

Privacy Statement
Press Release
Contact