TM 9-6115-668-13
5.29 SUBCURRENT FILTER OIL LINES MAINTENANCE.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Tool Kit
Reference
(item 2, appendix B)
Generator Set 150 kW shut
Automotive Fuel and Electrical System Repair, Tool Kit
down,
(item 3, appendix B)
paragraph 2.5.2
Materials/Parts
Sealing rings
Plastic Bags
(item 21, appendix E)
Rubber Bands
(item 22, appendix E)
Cable ties
(item 10, Appendix E)
REMOVAL
1.
Open flap (2, figure 5-41) on unit hood assembly (1).
C A U T I O N
l
Place a container under subcurrent filter and engine block, and col-
lect oil as it emerges.
l
Completely drain subcurrent filter and oil lines.
l
After disconnecting, plug oil lines and tie up.
2.
Remove drain plug (10), and sealing ring (11) from subcurrent filter (5). Discard sealing ring (11).
3.
Cut cable ties (28, 29).
NOTE
If oil lines are not to be replaced immediately, bag both ends of oil lines
(7) and (13) with plastic bags and secure with rubber bands to prevent
contamination.
Return hollow screws (9,15,23 and 27) to original position and replace
screw (10) with new sealing ring (11).
4.
Remove hollow screw (9) with oil line (7) and sealing rings (6, 8) from subcurrent oil filter (5). Dis-
card sealing rings (6, 8) and bag oil line (7).
5-170
