TM 9-6115-668-13
d. Remove screw (33), serrated lock washer (36) and spacers (37).
e. Remove two nuts (23), two serrated lock washers (24) and two washers (25).
f. Remove two screws (26), angle piece (32) and interlock switch S12 (17).
g. Use socket wrench (shop manufactured) to remove threaded ring (35) from threaded part on connector
receptacle L1 (16), holding nut (44 or 45) with a suitable wrench.
h. Remove connector receptacle L1 (16).
6.
Remove connector receptacles L2 (14) and N (10):
a. Perform steps 5a. through h.
1. Install connector receptacles L1 (16) and L3 (12):
NOTE
Installation procedure for connector receptacle L3 (12) Is the same as for con-
nector L1 (16), described below.
a.
Insert connector receptacle L1 (16) into control cabinet connection panel (9) from the front.
NOTE
Apply four drops of Loctite 243 to threaded ring before threading onto the back.
b. Install threaded ring (35) on threaded part (34) of connector receptacle L1 and tighten with socket wrench,
holding nut (44 or 45).
c. Place washer (43), cable (42), washer (41), serrated lock washer (39) on threaded terminal (38).
d. Install nut (39) on threaded terminal (38), holding nut (44 or 45) with a suitable wrench.
e. Install screw (33) on control cabinet connection panel (9) and serrated lock washer (36).
f. Install spacers (37) onto screw (33).
g. Insert two screws (26) on control cabinet connection panel (9) and install angle piece (32) with interlock switch
S12 (17).
h. Install two washers (25), two serrated lock washers (24), and two nuts (23) on two screws (26) and tighten
two nuts (23).
i. Place cover (46) on spacers (37) and screw on two nuts (47).
2. Install connector receptacles l2 (14) and N (10):
a. Perform steps 1 a. through i.
3.
Close control cabinet connection panel (9) and remove props.
4. Install eighteen screws (6), eighteen serrated lock washers (7) and eighteen washers 98) on control cabinet
assembly(3).
5. Stow prop (5) and close front panel (4).
6. To install unit hood assembly (1) refer to paragraph 4.14.
5-159
