ARMY TM 9-6115-464-12 AIR FORCE TO 35C2-3-445-1 NAVY NAVFAC P-8-624-12 1. 2. 3. 4. 5. 6. 7. 6. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. b. clamp Exhaust pipe Rain cap Heater  assembly Screw Flat washer Lockwasher Nut Heater control assembly Screw & captive washer assembly Valve Nut Elbow, 45 degree Adapter Elbow Adapter Coolant hose assembly Pipe nipple Valve 26.  Coolant  hose  assembly 27. Elbow 28.  Elbow 29.  Coolant  hose  assembly 30. Street elbow 31.  Tee 32. Pipe nipple 33.  Valve 34.  Elbow 35.  Elbow 36.  Fuel  hose  assembly 37.  Thermostat  switch 38.  Wiring  harness 39.  Clamp 40. Screw & captive washer assembly 41.  Nut 42.  Wiring  harness 43.  Protective  cover 44.  Plug  “WATER” Elbow 45.  Plug Pipe  nipple Tee 46.  Plug 47.  Plug Adapter 48.  Plug Pressuee  relief  valve 49.   Cap Elbow 50.  Cover Figure 5-1. Fuel Burning Winterization Kit Installation (Sheet 2 of 2) (10) Disconnect fuel line and remove elbow from fuel solenoid valve (paragraph 4-24). (11) Install fuel burning winterization kit following the ascending sequence of index numbers (1 through 50) assigned to Figure 5-1. NOTE Run  wiring  harnesses  through  existing  clamps  (39)  as  shown. (12) Install elbow removed in step (10) above and connect fuel line. (13) Fill cooling system with proper coolant (paragraph 3-27). (14) Install heater assembly protective cover (paragraph 5-7). (15) Loosen coolant hose (17, Figure 5-1) at water pump assembly and open valve (19) to bleed air from heater assembly and coolant lines. (16) Tighhten coolant line and close valve. (17) Add coolant to radiator as necessary. Replacement. (1)   Removal. (a) (b) (c) Refer to paragraph 3-27 and drain the engine cooling system. Remove  fuel  burning  winterization  kit  in  reverse  order  of  steps  (2)  through  (14)  in  paragraph  5-4a. above. Refer to paragraph 3-27 and service the engine cooling system with the proper coolant. (2)  Installation.  Refer  to  paragraph  5-4a.  above  for  installation  procedures. 5-3