Figure 7-43. Delivery Valve - TM-5-6115-585-34

Figure 7-42. Injection Pump Installation

TM-5-6115-585-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
113

(2) Timing Method 1. This is a means for calcu- lating the correct button thickness before the pump is installed. It requires the port closing dimensions and button thickness from the pump being replaced. Sub- stitute the dimensions for those in the formula below and calculate the new button thickness. Determine the button code letter from table 7-1. Example Formula: TM5-6115-585-34 NAVFAC P-8-262-12 TO-35C2-3-455-2 TM-05684C-34 NOTE Always use button thickness closest to this dimension. Install the correct button in pump (figure 7-33) and install pump following the instructions under injec- tion pump installation above. (3) Timing Method 2. Flowing the Pump. Port closing dimension of old pump (a) Install a Number 12 or M timing button in (removed from engine) . . . . . . . . . . 1.093 injection pump and install pump on engine, following instructions under injection pump installation above. Button thickness of old pump . . . . . . . +0. 119 1.212 Port closing dimension of new pump . . . . -1.089 When removing tappets which contain timing Button thickness of new pump . . . . . . . 0.123 buttons, do not allow the portion of the injec- tion pump which has the face gear to be lifted Use button M from its position. Figure 7-43. Delivery Valve 7-39

Privacy Statement
Press Release
Contact