Figure 7-47. Centering Sleeve Installation

Figure 7-46. Fuel Injector - TM-5-6115-585-34_149

Section II. MAINTENANCE - TM-5-6115-585-34_151

TM-5-6115-585-34 Generator Set Diesel Engine Driven Tactical Skid Mtd 5 KW 1 Phase 2 Wire 1 Phase-3 Wire 3 Phase-4 Wire 120 120/240 and 120/208 Volts Manual
Page Navigation
118

TM5-6115-585-34 NAVFAC P-8-623-34 TO-35C2-3-455-2 TM-05684C/05685B-34 (3) Mount injector in a suitable holding fixture. (4) Assemble valve (7) and nozzle (9) and install on body (15). (5) Install nozzle cap nut (12) loosely. When tightening nozzle cap nut do not contact nozzle valve (7). (6) Place centering sleeve TSE 773 over nozzle for initial tightening. Remove centering sleeve after initial tightening to prevent it from binding between nozzle and cap nut and tighten nozzle cap nut to 50 to 55 ft-lb dry. - (7) Adjust opening pressure of nozzle (see para- graph 7-20c). i. Installation. (1) Make sure old gasket material has been re- moved from injector. (2) Assemble new nozzle gasket (5, figure 7-45), adapter (6), gasket (7), heat shield (8) and gasket (9) on injector (4). (3) Install injector and assembled parts into cyl- inder head (10). (4) Install retaining flange (3) and tighten down with screws (1) and washers (2).” (5) Reconnect fuel lines as described in para- graph 7-2. (6) On ASK equipped generators, refer to Operator and Organizational Maintenance Manual and replace top panel assembly. 7-44 Change 6 Figure 7-47. Centering Sleeve Installation

Privacy Statement
Press Release
Contact