TM 5-6115-400-35
(c) Insert the tool assembly into the cylinder
block so the upper adapter plate is
between 1/32 inch and 1/16 inch below
the counterbore sleeve seat in the block
(d) Secure the upper and lower adapter
plates in the sleeve bores by tightening
the set screws (fig. 110).
(4) Adjusting and Operating Tool.
(a) To adjust the tool for cutting the correct
diameter in the counterbore, loosen the
1. Setscrew for securing lower adapter plate
knurled nut securing the tool holder.
Move the tool holder so the tool bit can be
2. Setscrew for securing upper adapter plate
extended into the counterbore about half
6115-400-35/110
way. Slide the tool holder until the tool bit
Figure 110. Securing cylinder sleeve reseating tool
just contacts the inside diameter of the
in block.
counterbore. Tighten the knurled locknut
securing the tool holder by hand only.
Carefully and slowly turn the tool to be
sure the tool bit does not tightly contact
the counterbore I.D. at any point in a
complete revolution.
The specified
original counterbore I.D. is
1. Counterbore sleeve seat
6115-400-35/111
Figure 111. Cylinder sleeve reseating tool installed.
6.229 inches to 6.234 inches. Readjust
tool holder, if necessary, so tool can be
revolved easily without excessive contact
with counterbore I.D.
Figure 109. Positioning cylinder sleeve reseating
tool.
143
