TM 5-6115-400-35
Table 1. Engine Repair and Replacement Standards-Continued
Manufacturer'
s
Maximum
Component
dimensions and
Desired
allowable
tolerance in
clearance
wear and
inches
clearance
Min.
Max.
Min.
Max.
Drive gear
O.D. of shaft for drive par .........................................
1.2505
1.2516
Bore in drive gear for shaft ........................................
1.2495
1.2500
Fit-shaft to gear .....................................................
------------
------------
0.0005
0.0020
...............................................................................
tight
Gear-upper shaft
O.D. of shaft for upper shaft gear .............................
0.7500
0.7505
Bore in gear for upper shaft ......................................
------------
------------
0.0000
0.0010
Fit-shaft-to-gear ........................................................
0.7495
0.7500
0.0000
tight
Gear-lower shaft
O.D. of shaft for lower shaft gear ..............................
1.2505
1.2515
Bore in gear for lower shaft ......................................
1.2495
1.2500
Fit-shaft to gear .........................................................
------------
------------
0.0006
0.0020
...............................................................................
tight
End play-upper and lower shafts ...............................
------------
------------
0.0020
0.0050
Auxiliary pump drive
O.D. of shaft for housing ...........................................
0.7510
0.7516
Bore in housing for shaft ...........................................
0.7495
0.7505
Fit-shaft-to-bore in housing .......................................
------------
------------
.0005
.0020
...............................................................................
tight
O.D. of shaft for bushing ..........................................
0.8720
0.8780
O.D. of bushing .........................................................
1.0025
1.0035
Bore in gear for bushing ............................................
0.9996
1.0005
I.D. of bushing installed ............................................
0.8745
0.8755
Fit-bushing-to-bore in gear ....................................
------------
------------
0.0020
0.0040
...............................................................................
tight
Shaft-to-bushing in gear clearance ...........................
------------
------------
0.0015
0.0085
Figure 1. Schematic wiring diagram.
(Located at back of manual)
schematic wiring diagram for this generator set.
11
