TM 5-6115-400-35
Figure 64. Accessory drive removal.
of gear up, and press upper shaft into gear until
precision type and do not require sizing after
the flange on shaft is tight against the
being installed. The specified diameter of the
counterbore in gear.
upper and lower shafts at the bushing locations
is 1.247 inch-1.248 inch.
(4) Install the upper shaft from thrust washer (5) in
position on dowel pins in housing and insert the
(8) Install a woodruff key in keyway on large
upper shaft, with gear, into housing. Rotate the
diameter of upper shaft (1). Position drive gear
shaft in the housing to be sure it turns freely.
(4) on bed plate of press with counterbored face
Lubricate the bushings and thrust washer.
98
