TM 9-6115-668-13
5.45
EHG TEMPERATURE SENSOR MAINTENANCE.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment
Conditions
Tools
General Mechanic’s Tool Kit
(item 2, appendix B)
Reference
Generator Set 150 kW shut
Automotive Fuel and Electrical System Repair, Tool Kit
down
(item 3, appendix B)
paragraph 2.5.2
Disconnect the negative battery cable first and then the positive battery termi-
nal cables. Failure to observe this warning could result In severe personal Injury
or death.
Tag all cables prior to removal to ensure correct connection of the cables during
Installation.
1.
Remove unit hood assembly (1, figure 5-50) as instructed in paragraph 4.14.
Remove first two cover panels (6) only, located next to partition (6).
2.
Remove eight screws (2), eight washers (4), and eight serrated lo&washers (3) from two cover panels (5) and
set panels (5) with air hose (7) aside.
Air hose doss not have to be removed.
3.
Remove flat connector 1J5 (8) and temperature sensor (9) from cylinder head.
4.
Remove round plug connector 1J30 (11) and temperature sensor (10) from cylinder head.
5.
Remove round plug connector 1J31 (13) and temperature sensor (12) from cylinder head.
5-208
