TM 9-6115-668-13
10.
Remove three nuts (9), three serrated lock washers (8), three washers (7, 3) and three screws (2) from bracket
(4).
11. Lift electrical oil pump (15) and air-oil heat exchanger (20) together, out of heat exchanger box (23).
12. Loosen clamps (11) and remove oil hose (14) from oil pump (15).
NOTE
Retain threaded fitting for reuse.
13. Remove fittings (13, 19) from air-oil heat exchanger (20).
1.
Install fittings (13, 19) by using sealing tape on air-oil heat exchanger (20).
2.
Install air hose (14) and clamps (11) on electrical oil pump (15), tighten clamps (11).
3.
Install electrical oil pump (15) and air-oil heat exchanger (20), into heat exchanger box (23).
4.
Install three screws (2), three washers (7, 3), three serrated lock washers (18), and three nuts (9) on brackets (4).
5.
Install oil hose (16) and damps (17, 18) on fitting (19), tighten clamps (17, 18).
6.
Install oil hose (5) with clamps (6) on electrical oil pump (15), tighten clamps (6).
7.
Install air hose (21) with clamp (22) on fitting on heat exchanger box (23), tighten clamp (22).
8. Refill oil as instructed in paragraph 2.3.2.3.
9. Install plug connector J 103 (10) on electrical oil pump (15).
10. Install cover (35) on heat exchanger box (23).
11. Install six screws (32), six serrated lock washers (33), and six washers (34).
12.
Install air hose (37) with clamp (36).
13.
Install unit hood assembly as instructed in paragraph 4.14.
5-191
