TM 9-6115-668-135.36 AIR FLAP PULLER MAGNET MAINTENANCE.This task covers:a. Removalb. InstallationINITIAL SETUPToolsEquipment ConditionsGeneral Mechanic’s Tool KitReference(item 2, appendix B)Generator Set 150 kW shutAutomotive Fuel and Electrical System Repair, Tool Kitdown,(item 3, appendix B)paragraph 2.5.2WARNINGDisconnect the negative battery cable first and then the positive bat-tery terminal cable. Failure to observe this warning could result in se-vere personal injury or death.C A U T I O NTag all cables prior to removal to ensure correct connection of thecables during installation.REMOVAL1.Open flap on unit hood assembly (1, figure 5-46).2.Remove screw (24) from plug connector X104 (25); remove plug connector (25).3.Loosen locknut (30) and unscrew tie rod (27) from fork member (31).4.Remove locknut (30) from tie rod (27) and remove helical spring (29).5.Remove four screws (40), four serrated lock washers (39), and four washers (38) from bracket (28).6.Remove air flap puller magnet (26) from bracket (28).INSTALLATION1.Place air flap puller magnet (26) on bracket (28).2.Install four screws (40), four serrated lock washers (39), and four washers (38) on bracket (28).Tighten screws (40).3.Slide helical spring (29) an locknut (30) on tie rod (27).4.Screw tie rod (27) into fork member (31) and tighten locknut (30).5.Install plug connector X104 (25) using screw (24). Tighten screw (24).C A U T I O NCheck that air flap closes and linkage moves freely.6. Close flap (2).5-187
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
