5.34 OVERTEMPERATURE SWITCH MAINTENANCE

Figure 5-44 Temperature Switch, Glowplug Maintenance.

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
510

TM 9-6115-668-13 5.34 OVERTEMPERATURE SWITCH MAINTENANCE. This task covers: a. Removal b. Installation INITIAL SETUP Tools Equipment Conditions General Mechanic’s Tool Kit Reference (item 2, appendix B) Generator Set 150 kW shut Automotive Fuel and Electrical System Repair, Tool Kit down, (item 3, appendix B) paragraph 2.5.2 WARNING Disconnect the negative battery cable first and then the positive bat- tery terminal cable. Failure to observe this warning could result in se- vere personal injury or death. C A U T I O N Tag all cables prior to removal to ensure correct connection of the cables during installation. REMOVAL 1. Open flap (2, figure 5-44) on unit hood assembly (1). C A U T I O N Do not pull flat connectors off cables. INSTALLATION 2. Remove both flat connectors X110 (18) on overtemperature switch S110 (17). 3. Remove overtemperature switch S110 (17) from heating unit (10). 1. Screw overtemperature switch S110 (17) into heating unit (10). N O T E Pass cables under cable bridges. 2. Connect both flat connectors X110 (18) on overtemperature switch S110 (17). 3. Close flap (2). 5-182

Privacy Statement
Press Release
Contact