TM 9-6115-668-13
CAUTION
Use only removal tool to push out contact bushings.
a. Insert removal tool into contact bushing from the front, and push contact bushing with cable out
of connector J9 (15).
1. Install contact bushings:
CAUTION
Use only installation tool to insert contact bushings.
a. Place installation tool over cable (10) and insert contact bushing into contact carrier of connector
J9 (15) from behind.
2.
Screw protective cap (16) on connector J9 (15).
3.
Install connector J9 (15), protective cap (16) and seal (14) control cabinet connection panel (9).
4.
Install screws (18) and washer (17) on control cabinet connection panel (9).
5.
Install washers (13), serrated lock washers (12), and nuts (11) on screws (18).
6.
Install cover (43) on spacer (41) and secure using two nuts (42). Tighten nuts (41).
7.
Stow prop (5) and close front panel (4).
8.
To install unit hood assembly refer to paragraph 4.14.
4-172
