4.60 LIGHT INDICATOR ASSEMBLY MAINTENANCE.

Figure 4-51 Control Cabinet Assembly, Cabinet Illumination H7, Door Contact Switch S3, Brightness Control N5 Maintenance.

INSTALLATION - TM-9-6115-668-13_279

TM-9-6115-668-13 5Kw 28VDC Auxiliary Power Unit (APU) MEP 952B Manual
Page Navigation
248

TM 9-6115-668-13 4.60 LIGHT INDICATOR ASSEMBLY MAINTENANCE. This task covers: a. Removal b. Installation Tools Equipment Conditions General Mechanic’s Tool Kit Reference (item 2, appendix B) Generator Set 150 kW shut Automotive Fuel and Electrical System Repair, Tool Kit down, (item 3, appendix B) paragraph 2.5.2 Materials/Parts Cable ties (item 10, appendix E) Disconnect the negative battery cable first and then the positive bat- tery terminal cables. Failure to observe this warning could result in se- vere personal injury or death. Tag all cables prior to removal to ensure correct connection of the cables during installation. 1. Open flap (2, figure 4-52) on unit hood assembly (1). 2. Open front panel (4) of control cabinet assembly (3) and secure with prop (5). Removal procedure for transformer T14 (6) is the same as for trans- former T15 (7) described below. 3. Record labeling and position of cables (8) on upper terminals (9) of transformer T15 (7), loosen screws (10), and remove cables, 4. Record labeling and position of cables (12) on lower terminals (13) of transformer T15 (7), loosen screws (11) , and remove cables. 5. Use a screwdriver to push locking element (14) on Transformer T15 (7) in direction of arrow, tilt transformer T15 (7) upward and remove from mounting bar (16). 4 - 1 4 4

Privacy Statement
Press Release
Contact