TM 9-6115-668-13
4.58 DOOR CONTACT SWITCH S3 MAINTENANCE.
This task covers:
a. Removal
b. Installation
Tools
Equipment Conditions
General Mechanic’s Tool Kit
(item 2, appendix B)
Automotive Fuel and Electrical System Repair, Tool Kit
(item 3, appendix B)
Materials/Parts
Reference
Generator Set 150 kW shut
down,
paragraph 2.5.2
Cable ties
(item 10, appendix E)
Disconnect the negative battery cable first and then the positive bat-
tery terminal cables. Failure to observe this warning could result In se-
vere personal injury or death.
Tag all cables prior to removal to ensure correct connection of the
cables during installation.
1.
Open flap (2, figure 4-51) on unit hood assembly (1).
2.
Open front panel (4) on control cabinet assembly (3) and secure with prop (5).
3.
Remove cables (30) from terminals (29) of door contact switch S3 (28).
4.
Remove screws (26) and serrated lock washers (27) from door contact switch S3 (28).
5.
Remove door contact switch S3 (28) from angle piece (24) on control cabinet assembly (3).
1.
Install door contact switch S3 (28) on angle piece (24) on control cabinet assembly (3) using screws
(26) and serrated lock washers (27).
2. Tighten screws (26).
3.
Noting correct labeling and position, connect cables to terminals (29) on door contact switch S3
(28).
4.
Stow prop (5) and close front panel (4).
5. Close flap (2).
4-141
