TM 9-6115-668-13
4.57 CABINET ILLUMINATION H7 MAINTENANCE.
This task covers:
a. Removal
b. Installation
Tools
Equipment Conditions
General Mechanic’s Tool Kit
Reference
(item 2, appendix B)
Generator Set 150 kW shut
Automotive Fuel and Electrical System Repair, Tool Kit
down,
(item 3, appendix B)
paragraph 2.5.2
Materials/Parts
Cable ties
(item 10, appendix E)
Disconnect the negative battery cable first and then the positive bat-
tery terminal cables. Failure to observe this warning could result in se
vere personal injury or death.
Tag all cables prior to removal to ensure correct connection of the cables
during Installation.
1.
Open flap (2, figure 4-51) on unit hood assembly (1).
2. Open front panel (4) on control cabinet assembly (3) and secure with prop (5).
3.
Remove cover panel (6) from lamp base (10) of indicator H7.
4.
Pull flat connectors (13, 14) with cables off contacts of lamp base (10).
5.
Remove nuts (7), serrated lock washers (8), and washers (9).
6.
Remove lamp base (10) and bulb (11) from threaded pin (25) on control cabinet assembly (3).
1.
Install lamp base (10) on threaded pin (25) on control cabinet assembly (3).
Tighten nuts on threaded pins to the torque value In table
(item G.2, appendix G).
2.
Install serrated lock washers (8) washers (9) and nuts (7) on threaded pin (25).
3.
Install flat connectors (13, 14) with cables on contacts of lamp bases (10).
4.
Install cover panel (6) on lamp base (10) of indicator H7.
5. Stow prop (5) and close front panel (4).
6. Close flap (2).
4 - 1 4 0
