TM 9-6115-668-13
The removal procedure for meter - AMPS L1 P1 (33), AMPS L2 P2 (34),
AMPS L3 P3 (35), VOLTAGE P6 (32), and BATTERY CHARGE P7 (31)
- is the same as described below.
4.
Remove KILOWATTS meter P4 (25):
a. Record labeling and position of cables (28) and disconnect cables from terminals (27) on KILO-
WATTS meter P4 (25).
b. Remove threaded rod (30), using hook (29) from housing (26) of KILOWATTS P4 meter (25).
c. Remove KILOWATTS meter P4 (25) from front panel (4).
The Installation procedure for meter - AMPS L1 P1 (33), AMPS L2 P2
(34), AMPS L3 P3 (35) VOLTAGE P6 (32), and BATTERY CHARGE P7
(26) - is the same as described below.
1.
Install KILOWATTS meter P4 (25):
a. Install KILOWATTS meter P4 (25) on front panel (4).
b. Install hook (29) and threaded rod (30) on housing (26) of KILOWATTS meter P4 (25) and
tighten threaded rod (30).
c. Noting correct labeling and position, connect cables (28) to terminals (27) on KILOWATTS meter
P4 (25).
The installation procedure for meter - HOURMETER P8 (16), OIL
PRESSURE P9 (14), and FUEL LEVEL P11 (16) - Is the same as de-
scribed below.
2.
Install OIL TEMPERATURE meter P10 (14):
a. Install OIL TEMPERATURE meter P10 (14) and insulation (22) on front panel (4).
b. Install retaining bracket (19) on OIL TEMPERATURE meter P10 (14), using serrated lock wash-
ers (18), and knurled nuts (17).
c. Noting correct labeling and position, install cables (20, 24) on terminals (21, 23) of OIL TEM-
PERATURE meter P10 (14).
3.
Stow prop (5) and close front panel (4).
4. Close flap (2).
4 - 1 3 8
