1. Remove four screws (1), lock washers (2), flat washers (3), and invert relay board assembly (4).
Other leads removed during removal of W11 harness leads must be replaced with any
2. Refer to relay board harness wire list (table 5-2), and tag and disconnect all W11 leads from terminal
board (5) and relay sockets (6).
3. Remove relay board harness W11.
Refer to figure G2, appendix G.
Position wiring harness W11 on relay board so that wire ends having terminal lugs are near TB1
Refer to table 5-2 and comect all W11 leads.
Position relay board assembly (4), and install four flat washers (3), lock washers (2), and screws (1).
5-10 OUTPUT CONNECTOR HARNESS W10 MAINTENANCE.
This task covers: a.
Tool Kit, General Mechanics
(item 1, appendix B)
Solder Gun (item 3, appendix B)
Both generator sets shut down; paragraph
Crimping Tool, Hydraulic (item 4, appendix B)
2-5.3.3. Trailer handbrakes set, front support
Multimeter (item 3, appendix B)
leg/landing lowered, and rear leveling-support
jack lowered; paragraph 2-3.2.1. Switch box